4
Indicates an (extreme) hazardous situation, which, if not avoided, will result in death, serious
injury�
Indicates a hazardous situation, which, if not avoided, can result in death, serious injury�
Indicates a potentially hazardous situation, which, if not avoided, can result in injury�
Indicates practices which, if not avoided, can result in equipment damage�
Indicates a hazardous situation that cause from a hot surface!
Indicates crushing risk to fingers/hand�
Explication of warning symbols
CAUTION
WARNING
CAUTION
NOTICE
DANGER
CAUTION
We declare under our sole responsibility that this product corresponds to the regulations 2006/42/EG, 2014/35/EU, 2014/30/
EU and 2011/65/EU and conforms with the standards or other normative documents: EN 61010-1, EN 61010-2-010,
EN 61326-1, EN 60529, EN ISO 12100 and DIN 12880�
A copy of the complete EU Declaration of Conformity can be requested at sales@ika�com�
EU Declaration of conformity
Safety instructions
General information:
•
Read the operating instructions completely before
starting up and follow the safety instructions.
•
Keep the operating instructions in a place where they can
be accessed by everyone�
•
Ensure that only trained staff work with the device�
•
Follow the safety instructions, guidelines, occupational
health and safety and accident prevention regulations�
Transport and installation:
CAUTION
•
Ensure that your fingers do not get crushed when setting
down the device�
•
Beware of the high dead weight of the device when trans-
porting�
•
Insufficient ventilation may result in the formation of explo-
sive mixtures� Only use the device in well ventilated areas�
•
Disconnect the mains plug before cleaning, maintenance
and transportation of the unit
Device setup:
DANGER
•
Do not use the device in explosive atmospheres, it is not
EX-protected�
• To avoid bodily injury and property damage, observe the
relevant safety and accident prevention measures when
processing hazardous materials�
WARNING
• Please pay attention to the dangerous spots of the device
in Fig� 2�
CAUTION
•
Media may only be processed or heated with this device in
safe operation without monitoring if their flash point lies
above the set working temperature limit� The set working
temperature limit must be at least 25°C below the flash
point of the medium in use (EN 61010-2)�
• The working temperature limit must be set in such a way
that the maximum permitted temperature is not exceed-
ed� Check the working temperature limit regularly�
