Initial operation
Operating Instructions of the dryve D3 V0.0
12/15
Setting the acceleration:
1.
Activation of the acceleration change mode by simultaneously pressing buttons S1 and S2 for at least 5 seconds
(LED 7 lights up red) -> LEDs 4 to 7 flash 5 times.
2.
Release both buttons
3.
LED 7 flashes at intervals -> number of flashes represents the set acceleration
4.
Change the acceleration by pressing button S1 until LED 4 "Motor running" lights up
5.
Release the button S1 -> The next acceleration is set and LED 7 flashes repeatedly corresponding to the selected
acceleration number
6.
After acceleration 5, acceleration 1 follows again
7.
To exit the acceleration change mode, press the S2 button for at least 3
seconds -> the LEDs 4 to 7 flash 5 times
For initial operation videos, see
igus.eu/D3