Installation
Operating Instructions of the dryve D3 V0.0
7/15
3.2.1
General information about the electrical installation
The dryve D3 was designed for connection to DC voltages.
All voltage specifications listed in this operating manual should therefore be regarded as DC voltage.
WARNING!
•
Danger from sudden movements
To ensure that the dryve D3 can be operated without interference, the voltage supply must not be executed as PELV (func-
tional extra-low voltage with safe insulation: Protection by extra low voltage, active conductor connected to ground or protec-
tive conductor). This can lead to unpredictable malfunctions of the D3 dryve.
3.2.2
Terminal assignment
Interconnect the connectors according to your application. Use the detailed illustrations for the individual terminals in the follow-
ing.
The terminals are connected as follows:
1.
Insulate the cores over a length of 8 mm
2.
Press the white spring of the core opening by hand
or with a screwdriver into the terminal block.
3.
Push the core deep into the opening.
4.
Remove the white spring out of the
connector again.
QR code video description