46
Display Settings and module options
Display & E Stop
Detector nodes with displays
or room status indicators can
be programmed to indicated
up to eight detector values
sequentially on screen. A
display option must be
selected. Select ADD and the
following screens are
displayed
The sensor readings to
display must be on the
same cable highway as
the module being
programmed to display
them. Select the detector
address to display, up to 4
characters to display for
the gas type and units of
measurement.
The example below shows the first available address programmed with detector address 5, gas as Pres
(pressure) and units as mBAR. You can toggle between page 1 and 2 to programme up to
2
detector
addresses. These will then be sequentially displayed on the detector node display. If the channels to be
displayed are on the same detector node as the display then selecting ‘Internal Sensors’ will automatically
assign whatever has been setup as channels on the detector node to the display channels.
