IEMCA KID 80, Руководство по эксплуатации и техническому обслуживанию

Страница: 80 / 82

EN
9 - PARTS REPLACEMENT KID 80
9 - Pag. 2 / 4
9.1 PRELIMINARY NOTE ON PARTS REPLACEMENT
Before carrying out any replacement, start all safety devices provided and check if it is
necessary to inform the staff operating around and people close to the area. In particular, it is
recommended to adequately signal the adjacent areas and to prevent anyone from approaching
all the devices that, if started, could cause unexpected damage and harm to people.
If it proves necessary to replace worn components, use only original spare parts.
We disclaim any responsibility for damages to components and injury to people derived from
the use of non-original spare parts and from any repair carried out without the manufacturer's
authorisation.
For spare parts ordering, follow the indications reported on the spare parts catalogue.
9.2 REPLACEMENT OF THE FIXED TIP
For replacement proceed as follows:
- Open the upper guard.
- Disassemble the bar pusher.
- Pull off the pin (A) to remove the fixed tip.
- Install the new fixed tip and fasten it by means of
a new pin.
- Install the bar pusher again.
- Close the top cover again.
9.3 FEEDING BELT REPLACEMENT
Follow the instructions given hereunder to perform
this operation:
- Open the upper guard.
- Loosen nut (B).
- Loosen the belt through screw (A) and lock nut.
- Disassemble the plate (C) and replace the belt.
- Assemble the plate again (C).
- Adjust the tension of the belt.
- Close the top cover again.