IEMCA KID 80, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 82

EN
5 - ADJUSTMENTS AND SETTING UP KID 80
5 - Pag. 4 / 6
5.3 LOADING AXIS ADJUSTMENT
Carry out guide channel height adjustment according to the section of the bars to be machined.
Please carry out guide channel height adjustment following these instructions.
Round bars: set the bar diameter measurement on the millimetre-counter.
Hexagonal bars: set the measurement of the wrench on the millimetre-counter.
Square bars: set the measurement (X) obtained from the following table, on the
millimetre-counter:
L =
mm X
5 5
8 8
10 10
12 12
15 15
18 18
20 20
22 22
25÷55 40
The adjustment has to be carried out according to the diameter of the bar to be machined.
For the adjustment proceed as follows:
- Rotate the knob (A) until displaying the diameter of the bar to be machined, on the
millimetre counter (B).
- Check that with the lifted guide (C), the bar is aligned with the loading axis.