IEMCA KID 80, Руководство по эксплуатации и техническому обслуживанию

Страница: 63 / 82

6 - USE AND OPERATION KID 80
EN
6 - Pag. 13 / 14
6.13 “STEP BY STEP”
You will have to activate a "step by step" cycle if you wish to check bar feeder operating
conditions: It is possible to start either a complete operating cycle or a partial cycle.
Complete cycle
It is possible to carry out this operation with or without any bar.
• Turn selector switch and hold it to the left; the bar pusher will reach its limit position.
• Turn selector switch and hold it to the left; the bar selecting and bar drop control
devices and the bar pusher are lifted.
• Turn selector switch and hold it to the right; the bar drop control device is lowered
and the guide channel lifts for pre-feeding.
• Turn selector switch to the right; the carriage carries out the pre-feeding.
• Turn selector switch and hold it to the left; the carriage goes back to its start position.
• Turn selector switch and hold it to the left; resetting the error on the display, the bar
pusher and the guide channel lower.
• Turn selector switch to the right to drive the bar pusher into the spindle liner.
Partial cycle
This operation can be carried out to remove a bar from the lathe.