NAS-4100 NETWORK ATTACHED STORAGE SERVICE MANUAL
Chapter 7
REINSTALLING FIRMWARE
Overview
Firmware Reinstallation Procedure
Overview
This chapter illustrates the steps to reinstall firmware on a NAS-4100 system.
Caution: After firmware reinstallation, all the existing configuration
data will be lost.
Note: This chapter only applies to the system with on-board flash. For
the system using Disk-On-Module (DOM), just replace the existing
DOM with a new one containing the right version of firmware. To obtain
the replacement DOM, please contact IEI Customer Support
Department or your sales representatives.
Tools Required
The tools you will need to reinstall the firmware of NAS-4100 is listed as below:
NAS-4100 Service Kit, including Firmware Recovery CD-ROM, Service
Manual, IDE Cable, Console (VGA and Keyboard) Cables
IDE CD-ROM Drive, including cables
One Monitor
One PS/2 Keyboard
Caution: Reinstalling the system firmware will cause the existing
configuration and data lost.
Firmware Reinstallation Procedure
The following instructions show how to reinstall the firmware on a NAS-4100.
Before performing the firmware reinstallation procedure, please have the
service kit and a CD-ROM drive with the IDE cable ready on hand.
To reinstall the firmware on the NAS-4100, please connect the console cables to
the NAS-4100 main board (refer to the Appendix B).
IEI CONFIDENTIAL
19
