Hangzhou IECHO Science & Technology Co., Ltd.
18
0.04MPa). Excessive air pressure can damage the grease or lubrication system of
the bearing. If the bearing loses lubrication, the bearing will be damaged under
the high-speed state of the spindle; if the air pressure is too small, the sealing
effect cannot be achieved.
The air source of the spindle must be filtered. Using an unqualified air source will
seriously damage the spindle stator coil and bearings, and affect the spindle life.
The main shaft cannot be hit by any kind of impact in any direction. After the
main shaft is hit, the dynamic balance will be destroyed, and even the bearing
will be damaged, affecting the service life of the main shaft.
Please use the matching professional tools for disassembly and assembly of the
chuck; if the bearing is damaged due to man-made reasons, no warranty
treatment will be done; if there is any problem with the spindle, please do not
disassemble and install it privately.
9. Daily maintenance of milling router
Check item
Check content
Require
Water
separator
1. Check the installation
2. Check the standing water
3. Check the air pressure
1. Must be installed vertically
2. Check whether the automatic
drainage is normal every day
3. Keep the normal pressure at
0.04Mpa
Milling router
body
1. Check whether the position
limiter is installed
2. Check the bottom of the
cutter body
3. Check the position of the
milling cutter chuck
1. The position limiter must be
installed before use
2. Clean the bottom with a brush
or wire every day
Residue
3. Frequently clean up debris
from the milling cutter chuck
