Hangzhou IECHO Science & Technology Co., Ltd.
10
The following prompt pops up, indicating that the save is successful.
（
Figure. 13
）
6.2. Spindle running-in
To start the milling tool for the first time, the spindle must be run-in. The spindle
manufacturer has done the initial run-in before the product leaves the factory.
However, if the spindle is out of service for a long time (more than 3 months), it must
be re-run-in before using it again.
Operation method
：
Start the Sycodrive software, on the SPINDLE RUN-IN page, first set the spindle
model 4033-AC-100000rpm in the Spindle run-in control column, then select the
running-in method as Downtime>3 months, and click [START] to start running-in.
（
Figure. 14
）
