IDTECK Star FINGER006, Руководство пользователя

Страница: 17 / 51

17
8. Installation of the Product
8.1 Template
•
Tear off the Template page (51p) at the back of this manual and use the Template to drill two 6-
32 holes and one ½” hole on the proper location of the wall to mount the Wall Mount bracket as
shown below.
(If the gang box is installed on the wall, skip this step.)
•
Using 2 screws, install wall mount to the wall.
•
Insert 5 O-Rings to the Wall Mount as indicated, then run the cable from the main unit through
the center hole and snap in place the main unit to Wall Mount. Make sure that the main unit is
secure locked in place with Wall Mount.
※ Caution
:
Before mounting the Star FINGER006/P / iPASS IP-FINGER006 / IDTECK
FINGER006SR unit to the Wall Mount bracket, an operational test of the unit should
be completed, because the locking pins will lock the unit to the Wall Mount.
Removing the unit from the Wall Mount bracket after it has been snapped in place
may cause damage to the bracket and prevent reattachment.