IDTECK Star FINGER006, Руководство пользователя, Страница: 42 / 51

42
12.4.6 READER TEST
12.4.7 INPUT / DIP SWITCH TEST
6. READER TEST
Reader Test allows you to test the reader(s). To begin the
test, press
<ENT> . While the LCD displays “SCANNING”,
present a card to the reader you would like to test, and the
LCD will display the reader number and the card number.
After the test is finished, press
<ESC> to exit.
NOTE: Reader#1 refers to the built-in reader of the
FINGER006, and Reader #2 refers to an external reader.
NOTE: You can also use Reader Test to check the number of
a card.
SCANNING…
READER #1
12345678
7. INPUT TEST
Input Test allows you to check the status of Input Ports and DIP
switches (Communication Address Setting Switches). To begin the
test, press
<ESC> .
1. DIP Switch: 1=ON, 2=OFF (It shows how the DIP
switch on the back of the FINGER006 is set.)
2. Input 1-4: 0=OFF (Disabled)
Input 1-4: 1=ON (Enabled)
Input 1-4: 2=Input Disconnected
3. Input 5: The status of the tamper switch inside the
FINGER006 (0=OFF (Disabled), 1=ON (Enabled))
4. Input 6: The status of the Proximity Sensor
(0=OFF (Disabled), 1=ON (Enabled))
If you activate the Cut-Off Check feature for all the input ports
in “5.IN/OUT DEFINE” from F2 Setup menu, the result of an
input port test will change to 222200 (If termination resistors
are not connected) or 000000 (If termination resistors are
connected).
INPUT TEST
10000100 000000
Card No.
Reader No.
Input Port
DIP Switch