MSD-62 Series User’s Guide
120
*1 If you set “RECV DISPLAY” to “OFF”, you cannot set this item.
*2 If you set “RECV DISPLAY” to “ASCII” or “HEX”, you cannot set this item.
*3 If you set only “LOOP BACK” of communication ports to “ON”, you do not need to set this item.
*4 If you set all “RCV CHECK” to “NOT CHECK”, you do not need to set this item.
*5 If you set “RS: RS-232C” to “ON”, set
” to “TRANSMITTER”.
*6 If you set any LAN connections for “LAN1” to “LAN8” to “ON”, set “
” to
“TRANSMITTER”.
*7 CEC: only power ON/OFF of the sink device can be controlled.
■
Setting loop back function
The MSD sends a communication command back to the MSD itself using the loop back function. It replies
“OK” if processed normally while replying “NG” if parameter or command is incorrect. To check the reply
command, set reply command 31 and 32 to “CHECK”.
■
Setting PJLink
The MSD supports PJLink, which is a standard protocol to control projectors.
To use PJLink, select the LAN connector for “COM port” so that you can select PJLink command when
entering the send command data.
【
See: 9.13.2 LAN operation mode
