Part 2 - Configuration
50
●
Min. Blocks: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under Zone for daytime and nighttime, each.
●
Actions: Specify which actions to take when motion
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
– EventUpload: Uploads the video clips when an
event occurs.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
●
Ignoring Interval: The system does not produce
event log entries or issue remote notifications
regarding motion detected for the time specified
after the initial motion was detected. Set the value
between 1 sec and 5 secs or choose Never.
Ignoring Interval does not affect motion detection
recording.
●
Daytime Setup: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
Trip Zone
No.: Select which cameras to apply Trip Zone to.
●
Sensitivity: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
●
Zone: Define the motion detection block.
Use the remote control’s arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the Camera buttons.
You can use the mouse to drag the zone and then select,
clear, or reverse the selection.
From the zone selection screen, press the
button
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
