IDEC WB1F Series, Руководство пользователя

Страница: 54 / 116

2. Installation & wiring Function 4. Support tool 5. Appendix 1. Overview
3-31
Setup support mode
3. 3. 2 Setup support function
The setup support function is a function to check barcode reading when installing the WB1F and a function to measure
the reading rate and reading count.
This allows you to easily adjust the WB1F installation and setup barcode positions and to adjust the line speed.
The setup support function can perform the following two measurements.
z
Reading rate measurement
z
Reading count mesurement
z
Reading rate measurement
This measurement outputs and displays the reading success rate each time 100 barcodes are read.
This can be used to check the WB1F installation and setup barcode positions.
The measurement results can be checked with the communication interface and the indicator LEDs.
An example of the measurement results output format is as follows.
Rate:[reading rate]: ID:[AIM ID] Code:[reading results data] Length:[barcode length] CR LF
* At this time, the global prefix is fixed as "none" and the global suffix is fixed as " CR LF ".
Example: When the reading rate is "100%", the AIM ID is "]E0", the reading results data is "4901234567894", and the bar-
code length is "13"
Rate:100%: ID:]E0 Code:4901234567894 Length:13 CR LF
The operation of the indicator LEDs is as follows.
Reading rate 0% 1-19% 20-39% 40-59% 60-79% 80-99% 100%
LED (green)
(G) (G) (G) (G) (G) (G) (G)
LED (orange)
(O) (O) (O) (O) (O) (O) (O)
LED (red)
(R) (R) (R) (R) (R) (R) (R)
z
To stop the measurement, push the Operation button or input the communication command suffix. (The
initial value is
CR LF )
z
When the measurement is ended, the unit returns to the same operation mode as before you switch to set-
up support mode.