Please
read
the
users
guide
before
installation
and
keep
it
for
future
reference.
Proper
Use
The
IPM5
/
IPW5
device
is
designed
for
the
evaluation
and
display
of
sensor
signals.
With
the
setpoints
it
is
possible
to
perform
simple
control
tasks.
Danger!Careless use or improper operation can result in
personal injury and/or damage the equipment.
Control
of
the
device
The
panel
meters
are
checked
before
dispatch
and
sent
out
in
perfect
condition.
Should
there
be
any
visible
damage,
we
recommend
close
examination
of
the
packaging.
Please
inform
the
supplier
immediately
of
any
damage.
Installation
The
IPM5
/
IPW5
device
must
be
installed
by
a
suitably
qualified
specialist
(e.g.
with
a
qualification
in
industrial
electronics).
Notes
on
installation
• There must be no magnetic or electric fields in the vicinity of the device, e.g. due to
transformers, mobile phones or electrostatic discharge.
•
The fuse rating of the supply voltage should not exceed a value of 0.5A N.B. fuse!
• Do not install
inductive consumers
(relays, solenoid valves etc.) near the device and
suppress
any interference with the aid of RC spark extinguishing combinations or free-wheeling
diodes.
• Keep input, output and supply lines separate from one another and do not lay them parallel
with each other. Position “go” and “return lines” next to one another. Where possible use twisted
pair. So, you receive best measuring results.
• Screen off and twist sensor lines. Do not lay current-carrying lines in the vicinity. Connect the
screening on one side
on a suitable potential equaliser (normally signal ground).
• The device is not suitable for installation in areas where there is a risk of explosion.
• Any electrical connection deviating from the connection diagram can endanger human life
and/or can destroy the equipment.
• Do not install several devices immediately above one another or in an extremely thermal
isolated housing. Due to the internal heat dissipation of the decives, the recommended ambient
temperature can be excessed.
• The terminal area of the devices is part of the service. Here electrostatic discharge needs to be
avoided. Attention! High voltages can cause dangerous body currents.
• Galvanic isolated potentials within one complex need to be placed on a appropriate point
(normally earth or machines ground). So, a lower disturbance sensibility against impacted
energy can be reached and dangerous potentials, that can occur on long lines or due to faulty
wiring, can be avoided.
3. Safety advices
5
3. Safety advices
