WF-2000 Series AIO
User’s Manual (Ver. 1.2, May./2014) ------------- 21
Table
2-6 WF-2026 Analog Input/Output Type Jumper configuration
Modules
Input Type
Jumper Position
Output Type
Jumper Position
Voltage
Voltage
WF-2026
Current
Current
2.6 FW / OP Dip-switch
On the top of the WF-2000 series module, there is a dip-switch used
for firmware operation or firmware update of the module. The following
steps show how to use this dip-switch.
2.6.1 Firmware Update Mode
Please set the dip-switch to the “FW” position as Figure 2-7, and then
the WF-2000 series will work in the “Firmware Update Mode” after reset
the power of the module. In this mode, users can update the firmware of
the WF-2000 module from computer’s RS-232 port via CA-0910 cable
shown as Figure 2-19.
Figure
2-17 FW Position of Dip-Switch
