TPD/VPD Series - Getting Started v.1.0.5
Page 61
Copyright@ 2012 ICP DAS CO., LTD. All Rights Reserved. E-mail: [email protected]
d.
Use the MAC Address that is displayed on the back panel of the TPD-283 to identify
the device module.
Set up the device as the picture below:
“Host IP Address” (PC): IP Address of the PC where HMIWorks is installed
“Device IP Address” (middle): IP Address for the TouchPAD
“Device IP Address” (bottom): IP Address used for downloading only
Tips & Warnings
Note: If the IP Address for the TouchPAD is set as “DHCP”, you will need to
wait for a while for the DHCP server to assign an IP Address to the
TouchPAD. The IP settings are saved in the project, NOT in the
TouchPAD, so the IP Address for the TPD-283 will not work until the
project has been successfully downloaded.
** After completing this step, please go to the
description of how to download the project before setting up the
second TouchPAD.
The HMIWorks software can only configure one TouchPAD at a time.
If
you replace an existing TouchPAD (Ethernet version), you must
IP Address of the PC
IP Address of the TPD-283
IP Address used for
downloading only
The IP Address must be in the same sub-domain.