http://www.icpdas.com
I8094A &I8094HGetting Started manual
Ver 1.3-- 82
CN5~CN8 (The I/O signals of the X, Y, Z, U AXIS )
The connectors CN5~CN8 are 15-pin connectors that enable users to connect the signals to
external motor drivers. Fig.1-8 shows the pin assignment for the 15-pin connector on the
DN-8468P, and the Table 1-9 shows its I/O connector signal description.
Note 1:
There are two sets encoder signals for X and Y axes. In X axis, one is from CNX
and the other is from CN5. In Y axis, one is from CNY and the other is from CN6.
Users can select encoder signals from JP1 and JP2, respectively.
Note 2:
In Z and U axes, only one set of encoder signals is used for each axis. In Z axis, do
not connect CNZ and CN7 at the same time. In U axis, do not connect CNU and
CN8 at the same time.
Note 3 :
Don’t connect NC (not connected) signals. Connecting these signals could cause
permanent damage to your motion controller.
