D
Direct frequency entry with keypad
The transceiver has a keypad for direct frequency
entry as described below.
q
Push [F-INP/ENT], then push the numeral keys on
the keypad to enter the MHz digits for the desired
frequency.
• If a key is mistakenly pushed, push [SET] (or any key
except keypad) and start again from the beginning.
• When entering the same MHz digits as the displayed
frequency, this step can be skipped.
w
Push [•] on the keypad.
e
Push the numeral keys to enter the frequency dig-
its below 1 MHz.
• If a key is mistakenly pushed, push [SET] (or any key
except keypad) and start again from the beginning.
r
Push [F-INP/ENT] to set the input frequency.
• When pushing [F-INP/ENT] after entering the MHz dig-
its, zeros are automatically entered for the kHz digits.
17
4
FREQUENCY SETTING
D
Using the tuning dial
q
Push [
∫
UP] or [
√
DN] one or more times to
select the desired ham band.
w
Select the desired operating mode with the mode
switch. (p. 20).
e
Rotate the tuning dial to set the desired frequency
• For general coverage receiver use
The IC-718 has a general coverage receiver band.
q
Push [
∫
UP] or [
√
DN] one or more times to select
the general coverage receiver band.
Note: Even if you select the ham band, you can set
the transceiver to the general coverage frequency.
When the displayed frequency exits the transmit fre-
quency range (ham band), a band edge beep may be
emitted (depends on initial set mode programming).
•To set to 21.025 MHz
•To set to 706 KHz (0.706 MHz)
•To set to 7 MHz
•To change 14.195 to 14.850 MHz
•Start
ENT
F-INP
V/M
1
NR
ANF
0
A=B
2
M=CL
5
ENT
F-INP
A=B
2
NR
7
SPL
ANF
0
M V
6
▲
ENT
F-INP
ANF
0
ENT
F-INP
7
SPL
ENT
F-INP
SCN
8
M=CL
5
NR
■
Frequency setting
[EXAMPLE]