Icom IC-718, Инструкция по эксплуатации

Страница: 30 / 62

The AT-180 automatic antenna tuner matches the IC-
718 to the connected antenna automatically. Once the
tuner matches an antenna, the variable capacitor an-
gles are memorized as a preset point for each fre-
quency range (100 kHz steps). Therefore, when you
change the frequency range, the variable capacitors
are automatically preset to the memorized point.
TUNER OPERATION
• Tuner type setting (p.46)
q
Push [PWR] for 1 sec. to turn power OFF.
w
While pushing and holding [SET], push [PWR] to
turn power ON.
e
Push [UP
Y
] or [
Z
DN] one or more times to select
[TUNER].
r
Rotate the main dial to select “18”.
• AT-180
AUTOMATIC ANTENNA TUNER
is selected.
NOTE: NEVER select “4” (AH-4
AUTOMATIC AN-
TENNA TUNER
), otherwise the transceiver trans-
mits automatically when turning the power ON.
Push [TUNER] to cancel unexpected tramsmis-
sion. Then, re-select the tuner type correctly.
y
Push [PWR] for 1 sec. to turn power OFF.
u
Push [PWR] to turn power ON again.
• AUTO TUNE:
Push [TUNER] to turn the tuner ON. The antenna is
tuned automatically during transmission when the an-
tenna SWR is higher than 1.5:1.
• When the tuner is OFF, “ ” goes out.
• MANUAL TUNING
During SSB operation on HF bands at low voice lev-
els, the AT-180 may not be tuned correctly. In such
cases, manual tuning is helpful.
Push and hold [TUNER] for 1 sec. to start manual tun-
ing.
• CW mode is selected, a side tone is emitted, and
“ ” blinks; then, the previous mode is selected.
If the tuner cannot reduce the SWR to less than 1.5:1
after 20 sec. of tuning,
“ ”
goes out. In this case,
check the following:
• the antenna connection and feedline
• the antenna SWR (p. 26; meter function)
• Through inhibit
The AT-180 has a through inhibit condition. When se-
lecting this condition, the tuner can be used at poor
SWR’s. In this case, automatic tuning in the HF bands
activates only when exceeding SWR 3:1. Therefore,
manual tuning is necessary each time you change the
frequency. Although termed “through inhibit,” the tuner
will be “through” if the SWR is higher than 3:1 after
tuning.
CONVENIENT
• Tuner sensitive condition
If you require critical tuning at any time during trans-
mission, select the tuner sensitive condition. See p.
51 for selection.
• Automatic tuner start
If you want to turn OFF the tuner under conditions of
VSWR 1.5:1 or less, use “automatic tuner on” and
turn the tuner OFF. See p. 46 for turning the function
ON and OFF.
28
5
RECEIVE AND TRANSMIT
CAUTION:
NEVER transmit with the tuner ON
when no antenna is connected. This will be dam-
age both the transceiver and the antenna tuner.
DO NOT!
connect the AT-180 and AH-4 at the
same time. Both turners will not be function cor-
rectly.
Y
Y
[TUNER]
Y
Y
[TUNER]
Tuning indicator;
Push and hold 1 sec. to start manual
tuning.
ï Optional AT-180
AUTOMATIC ANTENNA TUNER
operation