icetro IM-0350-AC, Руководство пользователя

Страница: 37 / 44

37
Cleaning and Disinfection
●
General
The end user has the responsibility to take good care of and repair this ice maker according to the descriptions
of this manual.
The insurance does not cover the maintenance procedure.
Basic sanitation and the maintenance and repair of ice maker will enhance reliability and performance and also
reduce water consumption and power consumption.
You can minimize unwanted repairs caused by maintenance if you manage the ice maker according to our rules.
The following table shows the maintenance activities that end consumers and service personnel must perform and
how often they need to perform them.
These figures indicate the minimum requirement. If low-quality water is supplied to the ice maker, you will have
to clean the evaporator more often. If the condenser's air filter is completely clogged, it needs to be cleaned
more often such as every week.
※Warning:
If you do not fully understand the essential safety rules and procedures, please contact
our agency to perform necessary repair.
[ Cleaning and Disinfecting Inside ]
●
General
Clean and disinfect the ice maker every six month for efficient operation.
If the ice maker needs to be cleaned and disinfected more often, consult a certified service company to check
water quality and take necessary actions.
If the condition inside the ice maker is not acceptable, disassemble key parts of the ice maker for cleaning
and disinfection.
※Caution:
Please use proven ice maker cleaning agent and disinfectant. (The cleaning agent is only
available from us or our agency.)
Please read and fully understand the label printed on the storage bin before use in advance.
Do not mix ice maker cleaning agent and disinfectant.
The type and concentration of sanitizing agent(Ice Maker Cleaner, Sanitizer, mild or neutral detergent,
and so forth)recommended
Comply with 40 CFR 180.9403 or
Be registered with the USA Office of pesticides program Antimicrobials Division
As a food contact sanitizer and
- If produced by a device, as defined per 40 CFR 152.5003, be demonstrable to be efficacious per USEPA
performance. The device shall maintain a USEPA Site manufacturing device establishment number and
- If produced by a device, as defined per 40 CFR 152.5003, have in place and readily discernable
to the operator a monitor or indicating device that the device is producing adequate amounts of sanitizing
agent during the sanitization operation.
※Warning:
Wear rubber gloves and goggles (or face mask) when using cleaning agent or disinfectant.
●
Washing Method
Ice maker cleaning agent is used to remove lime trace
and other mineral sediments.
It is not designed for removing fur or sticky mucous substance.
Refer to "Disinfection" section in the next page about removing fur
or sticky mucous substance.
Mix 150ml of cleaning agent and 4 liters of water in a plastic or stainless storage bin. Cleaning Agent (Nickel Safe Cleaner) Water
150 ml (16 oz) 4 Liters
Disinfectant (5.25% Sodium Hypochlorite) Water
200 ml 5 Liters