Ice SCRUB 35C, Руководство по эксплуатации и обслуживанию

Страница: 20 / 28

20 21 20 21
DAILY MAINTENANCE
4. DISASSEMBLING THE BRUSH
To clean the brushes correctly and effectively, proceed as follows:
1. the action of lowering the front squeegee (lever up) also serves to raise the brushing unit
2. loosen the three wing nuts fixing the side cover of the tunnel
3. remove the side cover
4. remove the two brushes
5. clean the brushes under a jet of running water; if the brushes are worn, replace them
6. reassemble the light blue brush at the rear, with the five grooves facing inwards
7. reassemble the white brush at the front, with the five grooves facing inwards
8. reassemble the side cover, being sure to insert the hub pins correctly in the brush grooves. If this
proves difficult, rotate the brush manually until the pins are in line with the grooves
9. fasten the cover by tightening the three wing nuts
Check the state of wear and tear of the cylindrical brushes and, if necessary, replace them. The brushes
should be changed when the bristles are about 10mm long.
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
WARNING: this operation must be carried out with the machine switched off
and the battery connector disconnected