Ice SCRUB 35C, Руководство по эксплуатации и обслуживанию

Страница: 13 / 28

13 13
MACHINE PREPARATION
9. BATTERY INDICATOR
The battery indicator is digital, with 4 fixed positions and a flashing one. The numbers which appear on
the display show the approximate charge level.
4 = maximum charge, 3 = 3/4 charge, 2 = 2/4 charge, 1 = 1/4 charge, 0 = batteries run down (flashing)
WARNING : a few seconds after the appearance of the flashing “0”, the brush
motor switches off automatically. With the remaining charge it is possible to
complete the drying process before recharging.
10. INSTRUMENT PANEL COMPONENTS
The instrument panel components are identified as follows:
1.
Main switch (1)
2.
Suction switch (2)
3.
Solenoid valve switch (3)
11. ASSEMBLING THE BRUSHES
The brushes are supplied loose, to prevent the bristles being crushed inside the packaging. To assemble
them, proceed as follows:
1. loosen the three wing nuts fixing the side cover of the tunnel
2. remove the side cover
3. insert the light blue brush at the rear, with the five grooves facing inwards
4. insert the white brush at the front, with the five grooves facing inwards
5. reassemble the side cover, being sure to insert the hub pins correctly in the brush grooves. If this
proves difficult, rotate the brush manually until the pins are in line with the grooves
6. fasten the cover by tightening the three wing nuts
ATTENTION: this operation must be carried out using gloves to protect against
contact with dangerous solutions
Take care not to mix up the brushes, the blue brush should always be placed in the rear idle hub.
Take care how the brushes are mounted, the assembly is correct if the direction of the bristles form an X
looking from above.
1
2
3