ICE RS26, powered by Brain OS | Gen2, v1.1217 – Content Subject to Change
34
Brain Corporation
MAINTENANCE AND SAFETY
WARNING
Before performing any maintenance on the machine, be sure that the power is
turned off and the batteries are disconnected!
WARNING
Repairs are to be
completed by authorized technicians only.
PREVENTIVE DAILY MAINTENANCE
1. Remove pad driver/ brush and clean with approved cleaner.
2. Drain recovery and solution tanks completely and rinse with clean water. Visually check
recovery tank for debris and clean out as necessary. Also clean out strainer basket.
3. Raise squeegee assembly off floor and wipe it down with a damp towel.
Be sure to store the squeegee in the up position.
4. Remove vacuum fan inlet filter and rinse it out with clean water.
5. Clean machine with water or a mild multipurpose cleaner and damp towel.
6. Recharge the batteries.
7. Check condition of squeegee blade wiping edge, rotate blade if worn. Replace if damaged. Wear of
brushes and squeegees will depend on surfaces being cleaned. Replace when the items are worn.
MONTHLY MAINTENANCE
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean recovery tank cover seal. Replace if damaged.
4. Lubricate all grease points and pivot points with silicon spray and approved grease.
5. Check machine for loose nuts and bolts.
6. Check machine for leaks.
MOTOR MAINTENANCE
1. Contact your local distributor for any motor maintenance.
2. Motor should have its brushes checked every 250 hours. Brushes should be
replaced when they are worn to a length of 10 mm or less.
BATTERY MAINTENANCE
CAUTION
Use the proper Personnel Protective Equipment
when handling and maintaining batteries.
1. Always follow battery charging directions as outlined in the
BATTERY CHARGING
section.
2. Keep battery tops and terminals free from corrosion. A strong solution of baking soda and water is the best way to keep
batteries corrosion free.
DO NOT ALLOW THE BAKING SODA/WATER SOLUTION TO ENTER THE BATTERY CELLS.
3. Use a wire brush with the baking soda solution to properly clean the battery posts and connections.
4. Check battery connections for wear and loose terminals. Replace if necessary
