IBM xSeries 342 2RX, Руководство по обслуживанию

Страница: 63 / 158

a. Turn the DIMM so that the pins align correctly with the connector.
DIMM 2
DIMM 3
DIMM 4
DIMM 1
b. Insert the DIMM into the connector by pressing on one edge of the DIMM
and then the other edge of the DIMM. Be sure to press straight into the
connector.Be sure that the retaining clips snap into the closed position.
c. Make sure the retaining clips are in the closed position. If a gap exists
between the DIMM and the retaining clips, the DIMM has not been
properly installed. In this case, open the retaining clips and remove the
DIMM; then, reinsert the DIMM.
d. Repeat steps 4a through 4c for the second DIMM; then continue with step 5.
6.
If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 62.
Installing a microprocessor
Your server comes with one microprocessor installed on the system board. If you
install an additional microprocessor, your server can operate as a symmetric
multiprocessing (SMP) server. With SMP, certain operating systems and application
programs can distribute the processing load between the microprocessors.
Notes:
1. Before you install a new microprocessor, review the documentation that comes
with the microprocessor, so that you can determine whether you need to
update the server basic input/output system (BIOS). The latest level of BIOS
for your server is available through the World Wide Web and the IBM Bulletin
Board System (BBS). The latest level of BIOS for your server is available
through the World Wide Web.
Installing options
55