IBM xSeries 342 2RX, Руководство по обслуживанию

Страница: 55 / 158

v
Review the documentation that comes with the adapter and follow those
instructions in addition to the instructions given in this section. If you need to
change the switch or jumper settings on your adapter, follow the instructions
that come with the adapter.
v
You can install full-length adapters in all expansion slots.
v
You can install a 32-bit adapter in any of the PCI slots.
v
Your server supports 5.0 V signalling and universal PCI adapters in slots 1, 2,
and 3; it supports 3.3 V signalling or PCI adapters in slots 4 and 5.
v
Your server uses a rotational interrupt technique to configure PCI adapters.
Because of this technique, you can install a variety of PCI adapters that currently
do not support sharing of PCI interrupts.
v
PCI slot 1 is on PCI bus A, PCI slots 2 and 3 are on PCI bus B, and PCI slots 4
and 5 are on PCI bus C. The system scans PCI slot 1, the system board Ethernet,
PCI slots 2-5, the system board SCSI, channel A, and the system board SCSI
channelB, if you have not changed the boot precedence from the default.
You can use the Configuration/Setup Utility program to change the boot
precedence for your server. Select
Start Options from the Configuration/Setup
Utility program.
Note: The Remote Supervisor Adapter must be installed in PCI slot 1.
Adapter installation instructions
Adapter
Expansion-slot cover
Installing options
47