IBM xSeries 342 2RX, Руководство по обслуживанию

Страница: 68 / 158

Power supply
Handle
DC power
LED (green)
AC power
LED (green)
Filler
panel
To install a power supply:
1. Remove the bezel. See “Removing the cover and bezel” on page 44.
2. Remove the filler panel from the empty power supply bay by inserting your
finger into the depression on the filler panel and pulling it away from the
server. Save the filler panel in case you remove the power supply at a later
time.
Note: During normal operation, each power-supply bay must have either a
power supply or filler panel installed for proper cooling.
3.
Install the power supply in the bay:
a. Place the handle on the power supply in the open position, pinch the
side-clips, and slide the power supply into the chassis.
b. Gently close the handle to seat the power supply in the bay.
4. Plug the power cord for the added power supply into the power cord
connector on the rear of the server.
5. Route the power cord through the cable-management arm.
6.
Plug the power cord into a properly grounded electrical outlet.
7. Verify that the DC Power light and AC Power light on the power supply are lit,
indicating that the power supply is operating correctly.
8.
Replace the bezel. See “Installing the server cover and bezel” on page 62.
60
Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG