IBM xSeries 342 2RX, Руководство по обслуживанию

Страница: 69 / 158

Installing an xSeries 3-Pack Ultra 160 Hot-Swap Expansion Kit
You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in your server
to provide three additional hot-swap hard disk drives.
Filler panels
Hot-swap expansion option
To install a xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in “Before you begin” on page 42 and in “Safety
information” on page 107 and “Handling static-sensitive devices” on page 43.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the cover and bezel. (See “Removing the cover
and bezel” on page 44.)
3. Release the side latches to remove the filler panels from the bays below the
CD-ROM drive.
4. Refer to the documentation provided with the option to assemble the hot-swap
expansion option.
5.
Slide the hot-swap expansion option into the bays and attach it to the server
with the screws provided in the kit.
6. Refer to the documentation provided with the option to complete the
installation of the option. (See “System board internal cable connectors” on
page 36 for locations of the cable connectors on the system board.)
7. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 62.
Replacing a hot-swap fan assembly
Your server comes with three hot-swap fan assemblies. You do not need to turn off
the power to the server to replace a hot-swap fan assembly.
Installing options
61