IBM TotalStorage FAStT FC2-133, Инструкция по установке и эксплуатации

Страница: 33 / 64

Adapter port name: World-wide port name.
Selectable Boot Settings
You can access the Selectable Boot Settings option for the FAStT FC2-133 Adapter
from the Configuration Settings menu. When this option is set to Enabled, you can
select the world-wide port name of the Fibre Channel hard disk from which you
want to start up (boot). When this option is set to Enabled, the node starts from the
selected Fibre Channel hard disk, ignoring any IDE or SCSI hard disks attached to
your server. When this option is set to Disabled, the Boot ID and Boot LUN
parameters have no effect.
The BIOS code in some new systems supports selectable start up, which
supersedes the Fast!UTIL selectable start up setting. To start from a Fibre Channel
hard disk attached to the FAStT FC2-133 Adapter, select the attached Fibre
Channel hard disk from the system BIOS menu.
Note: The Selectable Boot Settings option for the FAStT FC2-133 Adapter applies
to only Fibre Channel hard disk drives.
Restore Default Settings
You can access this option from the Configuration Settings menu. It restores the
FAStT FC2-133 Adapter default settings and NVRAM.
Raw NOVRAM data
This option displays the adapter NVRAM contents in hexadecimal format. This is a
troubleshooting tool; you cannot modify the data.
Advanced Adapter Settings
You can access this option from the Configuration Settings menu by selecting
Advanced Adapter Settings . The current default settings for the FAStT FC2-133
Adapter are listed in Table 4 and are described in this section.
Table 4. Advanced adapter settings
Setting Options Default
Execution throttle 1-256 256
>4GByte addressing Enabled or Disabled Disabled
LUNs per target 0, 8, 16, 32, 64, 128, 256 0
Enable LIP reset Yes or No No
Enable LIP full login Yes or No Yes
Enable target reset Yes or No Yes
Login retry count 0-255 30
Port down retry count 0-255 30
IOCB allocation 1-512 buffers 256 buffers
Extended error logging Enabled or Disabled Disabled
Execution throttle: This setting specifies the maximum number of commands
running on any one port. When a port reaches its execution throttle, Fast!UTIL does
not run any new commands until the current command is completed. The valid
options for this setting are 1 through 256. The default (optimum) is 256.
Chapter 3. Using IBM Fast!UTIL
19