IBM TotalStorage FAStT FC2-133, Инструкция по установке и эксплуатации

Страница: 28 / 64

/Y xxxx = Display port name of adapter at address xxxx
If no address specified, then display port name of all adapters
/L xxxx = Write NOVRAM, adapter address = xxxx
If no address specified then write NOVRAM to all adapters
/D xxxx = Copy NOVRAM to file: QL1xNVRM.SAV, adapter address = xxxx
/U xxxx = Update BIOS NOVRAM defaults, adapter address = xxxx
If no address specified then write then update all adapters
/N <filename.ext> = Use <filename.ext> instead of NVRMxx0.DAT
/T = Multiport Fibre Channel adapter
/X xxxx = Verify NOVRAM of adapter at address xxxx
Note: All of the listed options are supported and you can run them from the
command line. Options /L, /D, /U, /N, /T, and /X might not display.
The following list describes examples of additional command-line options that you
can use.
v
To write NVRAM on all FAStT Host Adapters in a system without being prompted
for I/O address, type:
flasutil /L
Press Enter.
v
To save the existing flash code to file QL2312RM.SAV, type:
flasutil /W F600
Press Enter.
v
To write NVRAM to the adapter at I/O address f400, type:
flasutil /L f400
Press Enter
v
To write NVRAM and flash an adapter at I/O address f800, type:
flasutil /L f800 /F f800
Press Enter.
v
To write NVRAM and flash all adapters, type:
flasutil /L /F
Press Enter.
v
To save NVRAM to file QL1xNVRM.SAV, type:
flasutil /D
Press Enter.
v
To update BIOS NVRAM defaults, type:
flasutil /U
Press Enter.
v
To verify NVRAM in all adapters, type:
flasutil /X
Press Enter.
14
IBM TotalStorage FAStT FC2-133 Host Bus Adapter: Installation and User’s Guide