IBM System x3755Types 7163, Руководство по установке

Страница: 22 / 88

Drive handle
(in open position)
Drive tray assembly
Filler panel
To install a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. Remove the filler panel from one of the empty hot-swap bays.
3. Make sure that the tray handle is open; then, install the hard disk drive into the
hot-swap bay.
Notes:
1. When you turn on the server, check the hard disk drive status LEDs to make
sure that the hard disk drive is operating correctly.
If the amber hard disk drive status LED for a drive is lit continuously, that drive
is faulty and must be replaced. If the green hard disk drive activity LED is
flashing, the drive is being accessed.
2. If the server will be configured for RAID operation using a ServeRAID
™
controller, you must configure the disk arrays before you install the operating
system. See the ServeRAID documentation on the
IBM ServeRAID Support CD
for additional information about RAID operation and complete instructions for
using ServeRAID Manager.
10
IBM System x3755 Types 8877 and 7163: Installation Guide