IBM System x3755Types 7163, Руководство по установке

Страница: 31 / 88

v
Non-hot-plug, half-length HyperTransport (HTX) slot.
Note: At least three microprocessor/memory cards must be installed to support a
HyperTransport adapter.
To install an adapter, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to install the device.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these devices,
see “Handling static-sensitive devices” on page 9.
3. Remove the top cover.
4. Determine which PCI expansion slot you will use for the adapter.
Adapter
retention latch
Adapter
retention bar
Pin
Pin hole
5. See the documentation that comes with the adapter for instructions for setting
jumpers or switches and for cabling.
Note: Route adapter cables before you install the adapter.
6. Install the adapter:
a. Open the adapter retention latch by lifting the front edge.
b. Remove the expansion-slot cover.
c. Lift up on the adapter retention bar.
d. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the I/O board.
e. If necessary, remove the adapter guide before you install a full-length
adapter.
f. Press the adapter firmly into the adapter connector.
g. Replace the adapter retention bar to stabilize the adapter.
h. Close the adapter retention latch. Be sure to align the pin on the latch with
the matching hole in the chassis.
7. Connect any required cables to the adapter.
Chapter 2. Installing options
19