IBM SAN384B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 59 / 190

Note: For rails with round holes, use the clip nuts (F in Figure 6 on page 20)
on the rails for securing the 10-32 screws. For rails with square holes,
use the retainer nuts (G Figure 6 on page 20). Also refer to Figure 7 on
page 22.
10.
Release the spring-loaded pins under the load plate, and slide the middle
section of the load plate back into load plate.
11. Lower the lift plate to its lowest position, release the wheel brake on the lift
tool, and move the lift tool away from the cabinet.
12. If necessary, adjust the rubber strips on the exhaust kit duct to ensure a good
seal against the chassis.
13. The chassis will be secured to the cabinet with six 10-32 screws with washers
(see Figure 14 on page 28). Four of these screws will also be used to attach the
cable management finger assemblies. Do not install the screws until you
determine the position of the cable management fingers.
Note:
Screws, clip nuts, and retainer nuts to secure the chassis to the cabinet
are provided in the SAN384B-2 hardware accessory kit.
Figure 13. Chassis half way into cabinet on load plate
Chapter 2. Installing a SAN384B-2 in a cabinet
27