IBM SAN Volume Controller 2145-CG8, Руководство по установке оборудования

Страница: 70 / 110

If the second line of each option for either Ethernet Port-3 or Ethernet Port-4
does not show
Link Online
when there is an Ethernet optical cable attached,
perform each of the following actions and check the display to see if the
action fixed the problem. If an action corrects the problem, you do not need to
perform the remaining actions.
v
Verify that an Ethernet cable is plugged into the node port.
v Verify that the other end of the Ethernet cable is plugged into the Ethernet
switch port and that the switch is operating correctly at a supported speed.
v
Replace the Ethernet cable with a new cable.
v Replace the 10 Gbps SFP.
When the required ports are online, check that the speed and duplex
operation are as expected. If either the speed or the duplex operation is not
what you expect, check the configuration of the Ethernet switch and check for
damage to the Ethernet cables.
Retain the MAC addresses as reference information.
10. Press and release the up button or down button until the
FC Port-1
option
shows in the display.
11. Check whether the second line of the front-panel display shows the message
Active
. If
Active
is not shown on the second line, go to MAP 5600: Fibre
Channel in the IBM System Storage SAN Volume Controller Troubleshooting Guide
to repair the fault.
12.
To display the current Fibre Channel port speed, press and release the right
button.
a. Press and release the right button to display the
FC Port-2
status.
b.
Press and release the right button to display the
FC Port-2
speed.
c. Press and release the right button to display the
FC Port-3
status.
d. Press and release the right button to display the
FC Port-3
speed.
e. Press and release the right button to display the
FC Port-4
status.
f. Press and release the right button to display the
FC Port-4
speed.
The operational speed of the Fibre Channel link is displayed. Use the cable
connection table that is provided by the customer to verify that the Fibre
Channel links are operating at the expected speed. If the operational speeds
do not match the expected speeds, go to MAP 5600: Fibre Channel in the
IBM System Storage SAN Volume Controller Troubleshooting Guide to repair the
fault.
13. To select a language other than English, perform the following steps:
a.
Press and release the up button or down button until the
Select
Language?
option is displayed.
b. Press and release the select button.
c. Press the left button or right button until the required language is
displayed.
The translated language names are displayed in their own character set. If
you do not understand the language that is displayed, wait for at least 60
seconds for the menu to reset to the default option.
d. Press and release the select button to select the language that is displayed.
If the selected language uses the Latin alphabet, the front panel display
shows two lines. The panel text is displayed on the first line and
additional data is displayed on the second line.
If the selected language does not use the Latin alphabet, the display shows
only one line at a time to clearly display the character font. For those
42
SAN Volume Controller: Model 2145-CG8 Hardware Installation Guide