IBM SAN Volume Controller 2145-CG8, Руководство по установке оборудования

Страница: 47 / 110

6. Install 2 clip nuts
2
and 2 M6 x 10 screws
1
, to attach the rail to the rear of
the rack.
7. Install 2 clip nuts
2
and
3
to the front of the rack. Then attach the rail
using just 1 M6 x 10 screw
1
in the bottom mounting hole as shown in
Figure 11 on page 20.
Note:
a.
The extra clip nut
3
is reserved for later installation of the 2145 UPS-1U
when the mounting brackets must be attached to the vertical rail on the
rack.
b. The rack might be different from the one shown here, and if so, might
require different clip nuts or fasteners.
2
1
svc00738
Figure 10. Attaching the rear of the 2145 UPS-1U rail to the rack
Chapter 2. Installing the SAN Volume Controller 2145-CG8 hardware
19