IBM RS6000 - 7026 - H70, Руководство по обслуживанию

Страница: 274 / 358

Table A-1 (Page 7 of 9). Service Request Numbers
SRN FRU List % Problem
50100 None – Description: An attempt was made to log
an error against a pdisk that is not
available to the using system.
Action: This problem has occurred for
one of the following reasons:
Ÿ
A user has deleted a pdisk from the
system configuration. In such an
instance, the hdisk that is related to
the pdisk continues to operate
normally. If the disk drive module
tries to log an error, however, this
SRN (50100) is produced. Enter the
cfgmgr command to return the pdisk
to the system configuration.
Ÿ
A disk drive module has tried to log an
error during system configuration. To
find the failing disk drive module, run
diagnostics to the disk drive modules
that are connected to this SSA
adapter.
60000 SSA adapter card 100 Description: The SSA adapter is missing
from the expected configuration.
Action: Verify that the SSA adapter card
is installed in the expected slot of the
using-system.
Ÿ
If it is in the expected slot, exchange
the FRU for a new FRU.
Ÿ
If it is not in the expected slot, enter
the diag -a command, and answer the
questions that are displayed.
7
xxxx
Disk drive module
Backplane assembly 80
20
Description: An SSA Hot-Swap Disk
Drive module is missing from the expected
configuration of the SSA loop.
Action: Replace the FRUs one at a time.
Go to "MAP 410: Repair Checkout" in
IBM
RS/6000 Diagnostic Information for
Multiple Bus Systems to verify each
repair.
D0000 Disk drive module 100 Description: The using system cannot
configure the disk drive module. This is
probably a software problem.
Action:
1. Try again to configure the disk drive
module.
2. If the problem remains, go to
“Software and Microcode Errors” on
page A-5 before exchanging the FRU.
A-12
Service Guide