IBM RS6000 - 7026 - H70, Руководство по обслуживанию

Страница: 142 / 358

3. Select either the service mode or the identify function. (For this example,
assume that you have selected the service mode function.) The list of pdisks is
displayed again, and the disk drive module that you selected is marked by a
>
,
which shows that the module is in the service mode.
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SSA SERVICE AIDS
8ð238ð │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SET SERVICE MODE
8ð2381 │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SET SERVICE MODE
8ð2382 │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SET SERVICE MODE
8ð2381 │
│ │
│ Move cursor onto selection, then press Enter. │
│ │
│ {TOP} │
│ │
│ pdiskð 11111111 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk1 22222222 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk2 33333333 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ > pdisk3 44444444 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk4 55555555 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk5 66666666 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk6 77777777 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk7 88888888 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ pdisk8 99999999 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ │
│ │
│ │
│ {BOTTOM} │
│ │
│ F3=Cancel F1ð=Exit │
│ │
└──────────────────────────────────────────────────────────────────────────────────┘
Notes:
a. You can select only one disk drive module at a time.
b. If you select the service mode function, and the selected disk drive module is
not in a closed loop (see “SSA Loops and Links” on page 3-59), your
selection fails and an error message is displayed. Use the Link Verification
service aid to identify any open-link problems before trying to reselect the
service mode function.
c. If you select the service mode function, and a file system is mounted on the
selected disk drive module, your selection fails. Use the Configuration
Verification service aid to determine which hdisk must have its file system
unmounted before you can select the service mode function.
d. If the check light of the disk drive module that you have put into the service
mode does not come on, and if you are not sure of the location of that
module, use the identify function to help you find the disk drive module (see
“The Identify Function” on page 3-65).
3-70
Service Guide