IBM pSeries 650, Руководство по установке

Страница: 169 / 190

Recovery Mode
If the service processor detects that its programming has been corrupted when it is powering on to
standby mode, it will enter recovery mode. In recovery mode, it prompts for the firmware update diskettes
by putting eight-digit codes on the operator panel display, as shown in the following table. After the update
process is complete, the service processor resets itself and performs a complete reboot.
Code Action
A1FD 0000 System firmware has been corrupted and must be reflashed.
A1FD 0001 Insert update diskette 1.
A1FD 0002 Insert update diskette 2.
A1FD 0003 Insert update diskette 3.
A1FD 000n Insert update diskette n.
Notes:
1. If the wrong diskette is inserted at any time, or if the diskette is left in the drive after it has been read,
B1FD 001F
is displayed, indicating that the wrong diskette is in the drive.
2. If B1FD 001A is displayed at any time during the process, the service processor must be reset by
activating the pinhole reset switch on the primary drawer operator panel.
Updating System Firmware from the AIX Command Line
For information about updating system firmware, refer to the Web site for detailed instructions on the latest
image provided.
Note: The update process can take up to 60 minutes, and the system reboots itself during the update
process.
Appendix G. Firmware Updates
153