IBM Netfinity 6000R, Руководство по установке

Страница: 33 / 66

© Copyright IBM Corp. 2000
21
Chapter 3. Starting the server
Use the following procedure to start your server.
1. Turn on all external devices, such as the monitor.
Note: After you plug the power cords into outlets, wait 20 seconds before
pressing the power control button. During this time, the system-
management processor is initializing and the power control button does
not respond.
2. Press the power control button on the front of the server. The power-on light
comes on and the power-on self-test (POST) begins.
Controls and indicators
Note: The illustrations in this document might differ slightly from your hardware.
The following illustration shows the controls and indicators on the server.
Hard-disk drive activity light:
Each hot-swap drive has a hard-disk drive activity
light. When this green light is flashing, the drive is being accessed.
Hard-disk drive status light: Each hot-swap drive has a hard-disk drive status light.
When this amber light is on continuously, the drive has failed. If an optional IBM
ServeRAID adapter is installed in the server, when the light flashes slowly (one flash
per second), the drive is being rebuilt. When the light flashes rapidly (three flashes per
second), the controller is identifying the drive.
Reset button: Press this button to reset the server and run the power-on self-test
(POST).
Power-control button: Press this button to manually turn on or off the server.
You can start the server in several ways:
• You can press the power-control button on the front of the server to turn on the
server.
Note: If you have just plugged the power cords of your server into an
electrical outlet, wait approximately 20 seconds before pressing the
power-control button.
Power-control button
Reset button
Hard disk drive
activity light (green) Hard disk drive
status light (amber)