IBM Multiprise 3000 S/390, Руководство по установке

Страница: 161 / 175

|
Appendix A. Discontinuing
| This chapter describes the steps necessary to safely shut down and disconnect the Multiprise 3000 and
| the Hardware Management Console.
| Before starting this procedure, be certain you have the required tools, instructions, packing and
| shipping materials for your particular system.
| Packing and instructions for PCI Crypto cards
| Obtain all needed materials before proceeding.
| Attention
| To safely power off the Multiprise 3000 and Hardware Management Consoles, all processing must be
| completed. The steps necessary to complete CPC processing will depend on your operating system and
| local procedures. Be sure that processing is complete before deactivating the CPC(s).
| All CPCs must be deactivated before power is removed. If you have a Hardware Management Console
| that has all of your CPCs defined to it, you can deactivate all of your CPCs with a single deactivation by
| deactivating the Defined CPCs group on that Hardware Management Console. If you do not have a
| Hardware Management Console that has all of your CPCs defined to it, you will need to perform the
| following steps on each of your Support Element(s):
|
Before Turning Off System Power
| Skip this step if you do not have the Cryptographic feature and go to deactivating the CPCs on page A-2.
| 1 Performing Cryptographic Zeroize
| From the Support Element Workplace panel.
| 1. Open Task List from the Views area
| 2. Open CPC Configuration from the Task
| List Work Area
| 3. Open Groups from the Views area.
| 4. Drag and drop the selected CPC onto the
| Cryptographic Coprocessor
| Configuration in the CPC Configuration
| area.
| 5. Select a CP from the list of CP's
| 6. Select Zeroize
| 7. Select Zeroize
| 8. Select Ok
| 9. Repeat until all "CP"s have been zeroized.
| 10. Select Cancel to exit Cryptographic
| Coprocessor Configuration.

Copyright IBM Corp. 1999, 2003
A-1