IBM Multiprise 3000 S/390, Руководство по установке

Страница: 162 / 175

|
Performing PCI Cryptographic Coprocessor Zeroize
| Skip this step if you do not have the Cryptographic feature and go to deactivating the CPCs on page A-2.
| 2 Performing PCI Cryptographic Coprocessor
| Zeroize
| From the Support Element Workplace panel.
| 1. Open Task List from the Views area
| 2. Open CPC Configuration from the Task
| List Work Area
| 3. Open Groups from the Views area.
| 4. Open the CPC group from the Groups
| Work Area .
| 5. Drag and drop the selected CPC onto the
| PCI Cryptographic Coprocessor
| Configuration task to start it.
| 6. Select the Zeroize All Coprocessors
| pushbutton to zeroize all PCI coprocessors
| at one time. A Zeroize Warning window
| will appear.
| 7. Select Zeroize All to confirm your choice.
| A message appears confirming that all PCI
| coprocessors have been zeroized.
| 8. Select Ok
| 9. Select Cancel to exit PCI Cryptographic
| Coprocessor Configuration.
| Attention
| To safely power off the Multiprise 3000 and Hardware Management Consoles, all processing must be
| completed. The steps necessary to complete CPC processing will depend on your operating system and
| local procedures. Be sure that processing is complete before deactivating the CPC(s).
| All CPCs must be deactivated before power is removed. If you have a Hardware Management Console
| that has all of your CPCs defined to it, you can deactivate all of your CPCs with a single deactivation by
| deactivating the Defined CPCs group on that Hardware Management Console. If you do not have a
| Hardware Management Console that has all of your CPCs defined to it, you will need to perform the
| following steps on each of your Support Element(s):
A-2
Installing the System