IBM IntelliStation M Pro 6219, Руководство по установке

Страница: 51 / 96

The following illustration shows the input/output (I/O) connectors on the rear of the
computer.
Power cord
connector
Mouse
Keyboard
Parallel
Serial 1
Serial 2
USB 2
USB 1
Mic
Line in
Line out
Ethernet
Video
1394
1394 IEEE
(FireWire) connector
Depending on the video adapter installed in your computer and the monitor you
want to use, you might need to use special video cables that convert signals or
provide an additional connection point for dual-monitor capability. See the
User’s
Guide on the IBM IntelliStation Documentation CD and the documentation that
comes with your monitor for additional information.
Turning on the computer
When the computer is connected to an ac power source but is not turned on, the
operating system does not run, and all core logic is shut down; however, the
computer can respond to requests, such as a remote request to turn on the
computer. The power-on LED flashes to indicate that the computer is connected to
an ac power source but is not turned on (standby mode).
Notes:
1. Turn on all external devices, such as the monitor, before turning on the
computer.
2. The power-on LED on the front of the computer is lit when the computer is on
and while it is being turned on.
3. You can install a circular disk over the power-control button to prevent the
computer from being turned off accidentally. This disk, known as the
power-control button shield, comes with your computer.
Approximately 20 seconds after the computer is connected to ac power, the
power-control button becomes active, and you can turn on the computer and start
the operating system by pressing the power-control button. The computer can also
be turned on any of the following ways:
v If a power failure occurs while the computer is turned on, the computer will
restart automatically when power is restored.
v When you plug in your computer for the first time, the Wake on LAN
®
feature can
turn on the computer. If your computer was previously turned on, it must be
properly turned off for the Wake on LAN feature to turn on the computer.
Chapter 2. Installing the hardware
31