IBM HS12 - BladeCenter - 8028, Руководство по обслуживанию

Страница: 52 / 204

Bezel-assembly
release
Bezel-assembly
release
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 31..
2.
If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 33 for instructions).
3. Open the blade server cover (see “Removing the blade server cover” on page
35 for instructions).
4. If an optional expansion unit is installed, remove it (see “Removing an optional
expansion unit” on page 37).
5. Press the bezel-assembly release on each side of the blade server and pull the
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
6. Disconnect the control panel cable from the control-panel connector.
7.
Pull the bezel assembly away from the blade server.
8. If you are instructed to return the bezel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Note:
1. The following illustration shows how to install a bezel assembly in a blade
server.
2.
The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
Bezel-assembly
release
Bezel-assembly
release
40
BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide