IBM FAStT200 HA, Инструкция по установке и эксплуатации

Страница: 38 / 114

20
IBM FAStT200 and FAStT200 HA Storage Servers Installation and User’s Guide
2. Connect the fiber-optic cable to the installed GBIC, as shown in the following
illustration.
3. Check the LEDs on the RAID controller. When the RAID controller is operating
properly, the amber Fault LED is off. For information about the status of the RAID
controller LEDs, see Table 4 on page 31.
To remove the fiber-optic cables and GBICs, do the following:
1. Gently pull the fiber-optic cable from the GBIC; then, replace the protective caps.
2. Move the metal latch on the GBIC to the unlocked (center) position.
3. Gently pull the GBIC out of the port; then, replace the protective cap.
Connecting hosts to the RAID controllers
To connect a host adapter to the RAID controller, do the following:
1. Install a GBIC in the host port on the RAID controller.
2. Connect the host-system cables to the RAID controller or to managed hubs and
switches. The following illustration shows the location on the RAID controllers
where the host-system cables connect.
For examples of redundant, partially-redundant, and non-redundant host and drive
loop configurations, see “Fibre Channel loop configurations” on page 11.
GBIC
Raid controller
Fiber-optic
cable
Controller A Controller B
Host A: Host Adapter 1
(or from managed hub
or switch) Host A: Host Adapter 2
(or from managed hub
or switch)