IBM FAStT200 HA, Инструкция по установке и эксплуатации

Страница: 93 / 114

Appendix B. Rack mounting template and instructions
75
Cage
nuts
Cage
nuts
Clip
nuts
5
Use the attached template and stickers to
mark the appropriate holes on your rack; then,
install clip nuts or cage nuts as required for
your rack cabinet.
Note: Use the cage-nut-insertion tool or a
flat-blade screwdriver to install cage
nuts.
6
On the rail marked R , remove the 6-32 in.
screw
3
and loosen the four screws
2
;
then, hold the front of the rail against the
outside of the right rack-mounting-flange and
loosely install two M6 screws
1
.
Extend the rear of the rail outside of the rear
rack-mounting-flange; then, install and tighten
two M6 screws
4
. Tighten the front screws
1
and repeat this step for the other rail.
7
Tighten the rail adjustment screws
1
on both
rails.
8
Remove the white screws and nuts
1
from
the storage server bezel; then, slide the
storage server into the rack. Align the bezel
locator pins and attach the bezel with two M6
screws
2
; then, install and tighten the 6-32
in. screws
3
.
9
Reverse step 1 through step 4 to reinstall the components that you removed; then, refer to your
storage server documentation to complete your installation. Store this information with your
storage server documentation for future use.