Installing the DDMs
Important:
The installation order within each drawer is from left to right in each row if you are facing
the front of the EXP5060. You must install DDMs in slots 1, 4, 7, and 10. Make sure that the
four DDMs in each row are adjacent to each other. The long edge of each DDM should touch
the DDM next to it. To maintain a uniform airflow across all drawers, the storage expansion
enclosure must be configured with a minimum of four DDMs in the front row of each drive
drawer.
Drive
drawer
Drives
Notes:
1.
The drive drawers are preinstalled in the EXP5060, but the DDMs are shipped separately from the
drive drawers.
2.
Make sure that you install the storage expansion enclosure in the rack cabinet before you install
DDMs in the storage expansion enclosure.
Drive
drawers
1
2
3
4
5
To install the DDMs in the drive drawers, complete the following steps:
1.
Starting with the top drive drawer in the storage expansion enclosure, pull the levers on each side of
the drive drawer towards the center to release the drawer.
2.
Pull the levers out from the storage expansion enclosure until the drawer is fully extended, but do not
remove it from the enclosure
3.
Starting with the first DDM, raise the DDM handle to the vertical position.
12
Содержание EXP5060
Страница 22: ...22...