IBM EXP5060, Быстрый старт

Страница: 8 / 24

Attention: Make sure that the screws are tight enough to support the weight of the storage
expansion enclosure, but do not completely tighten the screws yet.
7. Make sure that the holes in the rail above and below the top mounting screw are visible through the
holes of the rack flange and tighten the two M5 screws to secure the front of the rail to the rack
flange.
8.
From the rear of the rack cabinet, insert two M5 screws with washers through the rear of the cabinet
and screw them into the support rail rear flange.
9. Tighten the two rail adjustment screws with a medium flat-blade screwdriver.
10. Repeat steps 4 on page 7 through 9 for the right support rail.
Note: Because the mounting holes on the rack are not always the same size as the mounting screws,
the lip of each of the support rails might not line up evenly. Make minor adjustments as
needed to make sure that the lip of the left and right support rails are lined up evenly on the
racks. Failure to do so will cause the storage expansion enclosure to fit unevenly in the rack.
11.
Locate the two rear brackets, four M5 screws, four washers, and four clip nuts that are supplied with
the storage expansion enclosure.
12. Install the rear brackets at the rear of the rack as shown in the following illustration, using the M5
screws, washers, and clip nuts to secure the brackets to the rack mounting holes.
8