IBM DS3950, Руководство пользователя и инструкция по установке

Страница: 100 / 186

a. Turn on the power to the supporting devices (for example, Ethernet
switches and management stations) before you turn off power to the
storage subsystem.
b.
You must turn on the storage expansion enclosures before the storage
subsystem. The controllers might not recognize the correct configuration if
the drives are powered up after the storage subsystem. For instructions on
powering up the storage subsystem, see the storage subsystem
documentation.
c. Turn on the power to the storage subsystem; then restart or turn on the
power to the host.
9. Turn on the power to each device, based on the power-on sequence in step 8
on page 75. To turn on power to the storage subsystem and the EXP395s, turn
on the power-supply switches on the back of the storage subsystem. You must
turn on both power-supply switches to take advantage of the redundant
power supplies.
10.
Check the green Drive activity LEDs and the amber Drive fault LEDs above
the new drive FRUs.
Make sure that the Drive activity LEDs are on and the Drive fault LEDs are
off.
Note: The Drive fault LEDs might flash intermittently while the E-DDMs spin
up.
v
If the Drive activity LED is off, the E-DDM FRU might not be installed
correctly. Remove the E-DDM FRU, wait 30 seconds, and then reinstall it.
v
If the Drive fault LED stays on or the Drive activity LED stays off, the new
E-DDM might be faulty. See the DS Storage Manager software for problem
determination.
11. Use the DS Storage Manager software to configure the new E-DDMs. See the
DS Storage Manager software online Help for detailed instructions.
12. Restore the data from backup to all the E-DDMs.
Replacing the drives one at a time
Use this procedure to replace all the drives one at a time. You cannot use this
procedure on RAID 0 logical drives (use the procedure in “Replacing all E-DDMs
at the same time” on page 74).
Note:
If your storage subsystem has hot spares assigned, you might want to
unassign the hot spares while you perform this procedure. If you do not,
reconstruction might start on the hot spare before you insert the new drive.
The data on the new E-DDM is still rebuilt, but the process takes longer for
each E-DDM. Remember to reassign the hot spares when you are finished
with this procedure.
Attention: After you remove a E-DDM FRU, wait 70 seconds before replacing or
reseating it to allow it to properly spin down. Failure to do so may cause
undesired events.
To replace the E-DDMs one at a time, perform the following steps:
1.
Read the following information:
v
“Replacing multiple E-DDMs” on page 73, particularly the paragraphs that
discuss the differences between the two possible upgrade procedures
v
Your software documentation regarding drive upgrades and installation
v
The documentation that comes with the new drives
76
IBM System Storage DS3950 EXP395 Storage Expansion Enclosure: Installation, User’s, and Maintenance Guide