IBM DS3950, Руководство пользователя и инструкция по установке

Страница: 95 / 186

3.
Determine the bay into which you want to install the E-DDM.
4. Remove the blank tray by completing the following steps:
a. Release the latch on the E-DDM FRU by pressing on the inside of the
bottom of the tray handle.
b. Lift the closed latch to its open position. (The latch is at a 90° angle to the
front of the E-DDM when open.)
c. Pull the blank tray out of the bay.
d. Save the blank tray for later use.
5. Install the E-DDM by completing the following steps:
Note: The E-DDM comes installed in a drive tray. Do not attempt to detach the
E-DDM from the tray.
a.
Release the latch on the E-DDM FRU by pressing on the inside of the
bottom of the tray handle.
b. Pull the handle on the tray out so that it is in the open position, as shown
in Figure 35.
Tray handle
Tray latch
e
xp80012
c.
Slide the E-DDM FRU into the empty bay until the hinge of the tray handle
latches beneath the storage expansion enclosure bezel or the adjacent drive
FRU bezel.
Figure 34. Hot-swap E-DDM LEDs
Figure 35. E-DDM FRU handle
Chapter 5. Installing and replacing components
71